

8·
5 months agoI need a THDU on that one…
Too hard, didn’t understand.


I need a THDU on that one…
Too hard, didn’t understand.


Or 907 kg. So almost a metric ton, which is 1,000 kg (or 1.000 kg for some).
This shit isn’t at all confusing /s


I just sprinkle it on, if it’s too much it can just be blown off.
It also helps to add structure to the bond. The baking soda can build up and add strength.


I often print 3 walls and 10% infill and the prints are plenty strong. These are not high stress objects, but they can take plenty of stress without breaking.
I did print some curtain rod holders for some outdoor curtains. They had 3 walls and I think 25% infill. They do get a lot stress from the wind blowing, but they have held up very well in the 3 months they have been up.
That’s a damn good explanation, thanks!