layer lines create crevices that are difficult to clean. If you aren’t willing to sand the piece, your resin coat probably won’t change that.

I assumed (without evidence) the resin would tend to level out rather than retain those layer lines, but I suppose the viscosity might affect that and I don’t know how viscous the once I’m looking at is.

e.g. https://www.reddit.com/r/3Dprinting/comments/8mt9vk/comment/dzqxfda/ [comment has before shot, OP has after]

Agreed. It’s a conversation topic, I fully agree.

What’s the cheapest way to gaslight these data points?

Let’s say one has $10 to spare, what would you buy to ruin their model?

Adblockers have been mentioned a hundred times, as they should.

Annual reminder to donate to Invidious too. YouTube has done some serious work to try and block most of the instances.